The Jalopy Journal
That number is on the intake deck. Can't say if I ever saw one there along with the numbers look like it wasn't done at the factory but maybe a...
That's interesting info right there. Might make me reconsider what I am doing with one of my projects.
Does it have tube shocks now??? Looks pretty stock. I would start there before you do all the other things you mentioned.
I got references from my machine shop. He sent me to two or three. These guys all talk and pass work among themselves.
One thing I found was I...
I had my 49 Merc block sleeved on one cylinder. Think it was number one if I remember right. It cost right around $100.00 at my machinist. It was...
A fairly simple way to lower the ass end is to use a T spring.
what Moriarity said.
Me too regarding the red x's
Your at the wrong site to be talking Mustang II front ends. Nothing wrong with the factory front end. Hell he raced it right and it survived....
Blue flame???? On what an exhaust pipe??? rusty water??? Did you check your coolant level??
Interesting....how big are those brakes and what if any offset does the backing plate have. Curious what drums you would out on them.
4" without fenders...2.5 to 3 with fenders
Just don't buy directly from Howells. They sell to all the vendors. Life will be much easier purchasing them from your favorite vendor.
35 drums are pretty hard to come by if that is what they turn out to be. A one year only thing. Don't throw them away.
Look at 32 34 perches. I think they are longer than the A perch.
Glad you got rid of the hacksaw blade....it was truly a RR eyesore and didn't belong on your build.
There's a 39 handle for sale in classifieds right now.
clogged fuel filter is my guess.
Pretty sure 53 chevy's had them as well. Not sure about self cancelling though.
You can rebuild the 352 FE a lot cheaper than $4500.00. Depends on how much work you can do yourself. I would keep the 352. It's a great engine.
I'd like to see that. Never saw one with a cast number 18.
Like Clark said pay attention to the hole for the valve stem also. They tend to rot away. Sounds like you are buying from pictures. To far away to...
Are those 16" or 17". Can't see the condition of the stud holes with the caps on. Good ones go for $200.00 $250.00 apiece if they are 16" and in...
Never seen it done that way. Pretty intriguing. I need to keep watching this thread.
I had never seen that car before...pretty neat and good workmanship.
Oil pressure sending unit.
Please keep the poncho....it's a much safer car you can enjoy with your family a lot easier then the A sedan.
I took mine to a drive shaft service company. I measured everything and marked it where it needed to be cut and they did it. Keep in mind that the...
What's unusual about that relief job???
I used those inserts on my floor. When I need to use them I just blow it our with my air compressor.
Separate names with a comma.