The Jalopy Journal
they are a lucas unit fittied to lots of things old mini , mgb, land rover etc etc
the 'inner wire' is called a wiper motor rack drive cable and...
electronic tails electronic speedo drive
they pulse the same, as it may be the same part as a 700r-4 @ 16,000 pulses per mile?
bmx bike bottom bracket
Hello, this was bamboozling me for a while...…….
the black frame IS a 37 pick up, I 'DO' seem to remember finding a stamped in cap I or h in...
found it... large 'H' stamped into x-member = heavier guage frame,
question, is the actual stamping of a 42 -43 44 frame rail,
the same as 35-40...
has one of the self adjusting cables in the rear snapped
yes, dyeing with urine is something to do with lanolin and uric crystals, Scottish tweed.
"are you taking the piss"?
I'll see your remote and rasie you a
rover v8 or 216 buick bell housing from a tvr with the mustang box
funky forward shift from a tvr
If I only have 1/2'' of travel, what tyre pressure do I run?
take a SsangYong musso, or rexton 2001 t5 -
the thick belts are 5/8ths ''
thin belts 3/8's
you can only run them with the front cover and 8ba distributor
8ba thin pulley
8ba and 8cm...
where you buy those ones with the miss truck logo?
go to 35-40 ford chassis tech
your chassis has everything that is on the list.
I think you have to run a vent bolt, if you use the brass block 3 way union.
they do them shorter if you use a 68 mustang rear brake...
Yes Rich, Thank kyou - I will be 56 inches to the wheel mounting faces.
I may have to look into a 47'' one,
ooh, whilst on, are your deep drop...
so you fit a 46 inch wide axle in a 37-40
as the above pic with the chassis engineering 35-40 steering arm a smidgers over, it might be correct...
I think you just bought those from me?
I think it flukes out.
take a 37-41 spindle, from a car with 112 inch wheel base, 48.5 king pin centres
fit the spindle to a 32 ford with a 46...
If its a new brake master cylinder, say a gm c3 corvette style and you have set it up so you cannot fully stroke it, especially if you have a...
Thank you so much Seb and Rich for posting the pics, brilliant.
Sebs pic with both arms differing eye positions. - GREAT
I think this is due to...
ahh, so reading between the lines.
that year axle could work with 32 ford spindles - 37-41
the previous owner found some chevy or f1 spindles with...
could the bolt on arms be correct considering the axle has been narrowed from a stock 37-41 king pin distance
are they designed for a 47 inch king...
do me a favor please kind sir!!
does that bolt on arm actually sit in the other side? I don't suppose it will make any...
are they forged with eyes both sides, why does it...
oh, if its a smiths hard line oil pressure guage you planned on using it that flathead
The threads are probably BSP - british standard pipe...
Separate names with a comma.