The Jalopy Journal
this holding up well due to it not being tapered? I need to do some fixing on my b block
I want one!
I will also be using this. Thanks for the suggestions
This is awesome!
I will get a bottle of this as well. Thanks!
I will get a bottle of this as well. why not at this point!
The the cracks were in places I could not get to, The place I covered had already been stitched, but not properly... More crack were seen from...
So I am goin to give this a try! Plan is that I will smooth this out in a couple days and reassembled the motor back to the stock condition, once...
I agree with you 100%, that stripping it down and taking it to a shop is the best and most professional fix. I just don't want to strip the motor...
I seen that. 2400degrees!! I’m pretty sure my brazing rod melts before that.. If so it can withstand what I need.
Hahahaha I am! This might be the issue
Its just for a skim coat that doesn’t deal with really any pressure... there has to be something out there. I’m sure I can run it as is. Just...
Temp is the issue... It really is just for a skim coat. Thanks for the suggestion. I will have to look into it more. Thanks
Also why when I upload photos they are upside-down...?
So I found my culprit that has been feeding my exhaust antifreeze... I took down my model "B" block today to find an old repair. Someone stitched...
this is the setup I’m looking for. Nice!! Any mother mods to the engine? Also where did you notice the “gains?”
Nice I’ll have to check it out. I do like the burns intake and the price is better as well!
I figured the same. It’s probably not worth the time, I might just wait till a performance head comes my way.
Charlie thank you for the information. Who will be making this head that you are talking about?
this is true! The only thing is if I go that route I rather just put the cash toward a v-8 swap. Just would like this thing to keep up with normal...
I just bought his book today. Looking forward on reading it. I’m not goin to go deeper till then. Thank you for the information!
I am in the middle of doing a facelift on my model B motor. I pulled the head bc of a gasket issue. While it’s off, I though maybe I can get a bit...
Sent from my iPhone using The H.A.M.B. mobile app
I will be doin a v-8 water pump swap as well. I would like to drop the crank pulls to a 3” as well if it dosnt require dropping the pan. But I...
So you can block these holes with no problem. Nice to know.
Is there any heads out there that are around 7:1? Is like to get a lions or a...
With installation of an “A” head on a “B” motor. Blocking the two steam ports between cylinder 2-3 is not an issue? How did you go about this so...
Might be interested in some of these parts. I know I could use a fuel pump. Building a B motor now.
Nice car! What you running for a carb? 97, 81, ?
Separate names with a comma.