The Jalopy Journal
Definitely understand but the races will be missed! No doubt about it.
Wow that's both sad and crazy to hear! I've been looking for a first vehicle/project for my son but my Mopar knowledge is squat.
Any chance you'll expand on proportioning valves? I didn't install one on my Impala when I converted the front to disc. The very first time...
Ended up using Scotty's. $175 out the door.
Went by Inland yesterday. $300 to retube the rear section. Plus extra to disassemble the driveshaft. I’m on hold until I figure out if that’s the...
Installed a Ford 9" in my 61 and now needing a longer rear DS section. Looks like my choices are Scotty's and Inland. Who do you guys like?
Thanks again for the taking the time to post. We spoke with you guys Friday afternoon as things were wrapping up. Had us rolling! :)
Using a Super T-10 in my 61. I had options for sure but i'm loving the 4speed so far (the car had a TH350 when I drove it in highschool). I...
Intersection of Barton Springs and Lamar in Austin.
I would post up your choices if you plan on parking anything nice during your stay. Some of the hotels along I35 are shady as hell.
Clear Vue Concepts. They have a FB page if that helps.
Curious about your wheel/tire package. I like the way the rears fill the space. Awesome looking 61.
Precision built my dual quad 409. I'm happy with the work but so far all the motor has seen is break-in.
My favorite years but i'm highly biased. Hoping to see some different x-frames tomorrow at teh Round Up!
Yep. Looks like this loser has hit a few different boards recently with the same MO. My first home was less than a mile from the address he used....
Post up their screen name. And whatever else you may have.
Thank you very much guys!
There was a vendor, from the Dallas area I think, offering some pretty good whole-car glass deals in the swap meet area. Anyone recall who that...
I had Precision Engine Service build my 409. At 290 and I35.
Badass! Nice ride!
I'd drive it.
Don't be afraid to post wanted ads. There are a couple sites that i've used to get parts for my 61. Some of the parts that I had a hard time with...
You'd have to open the X in the frame in order for that to work, right? I'm sure i've heard of guys doing a one-piece.
So impressive! I would have never thought it. Cant wait to see the finished product.
Good info Oldtimer! You answered something i've been considering. That being with a telescoping rear shaft, the high dollar bearing may not be...
You had the jack stands under the rear suspension when you tightened the carrier bearing (sama as if it were sitting on the ground)? Just want to...
Precision Engine Service at 35 and 290 built my 409. May try them.
The chevytalk message board would give you a greater membership to pull from when it comes to these great cars.
Did you use the Peal and Seal for deadener?
Separate names with a comma.