The Jalopy Journal
Most places will have a minimum charge, if you don't have enough stuff to make it worthwhile consider looking around locally for someone else with...
Nothing you can apply at home will be worth a damn, ceramic coating eventually goes to shit too. Stainless is the only way to go
Rotozip = not traditional
700r4 = not traditional
Five bucks says this is what's up
Epoxy primers should be applied to clean bare metal sanded with 80 grit, and applied sparingly over filler that you've applied to clean bare metal.
I'd say use the flathead in your car and try to score an 80's four banger or maybe a little diesel for the welder, better on fuel and probably a...
Paint looks good, color is awesome! I was going to ask for pics of your econoline but you read my mind
If it were old enough to be pre-injection wouldn't it be a v-belt drive, not a gilmer? Pretty sure those are efi fuel rails
The ethanol they put in gas these days won't hurt them, good choice for e-85 too
glass cleaner and a razor blade
If you work in an environment that's not constantly noisy, earplugs are a pain in the ass. They always get dirty when taken out, and metal...
All electric fuel pumps should be installed as pushers. Electric fuel pumps use the fuel to cool the pump motor, and using them as a puller causes...
I like the one of Christine being born
Sasquatch air freshener that smells like pine trees :D
Along with a few plates?
What does this thing idle at? I read an install article on them and it said they couldn't get the engine to idle below 1500 rpm
I remember a magazine feature about this one, had the centerfold on my wall as a kid, the predator carbs are a dead giveaway
Did they really put CIS on motorcycles?
I second this, just get a good high quality oil fortified with ZDDP, your cam will love you for it! Quaker State has a high mileage oil that...
Attaches to the end of a rope to allow lifting donkeys out of wells
This is a traditional hot rod site, innovation is frowned upon:rolleyes:
Nice shading on the flames! And I like your booth too;)
I'd forgo the rust bullet, Just weld it up solid, gring your welds (not too much in one spot, you can warp a panel grinding welds), be sure any...
This isn't a good place to skimp, think of how much money you have in a finished engine, even a mild build. What's a couple hundred bucks to make...
Highest price ever paid for a Ford?
Edit: Apparently a gt40 went for eleven million, jesus!
Is this a strictly canadian thread or can I join the welcome party?;)
Fractions suck ass! It's so much easier to find center of something that's 253 mm than something that's 10 1/8"
Separate names with a comma.