The Jalopy Journal
Do you have the address where one of these can be bought from?
Thank you much, I will print out several copies for myself and friends and place one in my build folder too. Best wishes, Steve
I am finishing the front end of my 1930 coupe and am installing 1939/42 hubs and brakes. Can anyone post all of the Timken numbers currently...
Back to the start, I'll ask it again.
When using a replacement wheel stud (1940 style...) from any of the major suppliers, are the wheel studs that are currently available either grade...
Has anyone purchased the new Speedway 45 fin aluminum drums yet, and used them? I am looking for some feedback regarding their fit and...
A question that most of us who play with sheet metal (old cars) , but few would come out and ask: what do you use for the cracks on and around...
Hi Gary; yes its true that many of the commercial truck tire shops and service centers will have a machine - BUT - they will not offer their...
Yes, these are the seals inside the axle bells that keep the rear end fluid out of the brakes. Since there are no seals in them now I will...
Has anyone come up with good way to repair the seal area on an axle that has worn down? The axle in question is for a 1940. I have searched the...
Ok, I broke down and finally found & bought a machine so I could do the job myself. I am located just south west of Chicago and can be contacted...
Ok, I broke down and bought a machine or myself and to possibly help others that might be in the same situation I was in . I am located just...
Nope, not at all -- I was just trying to kill some time (like near 3 hours worth) waiting at the doctors office and wanted to do some reading...
Easy.... Each time i endef up on their site i could not view their catslog nor could i get the email to come up. Sorry that i put so many people...
Does anyone have a current email address for Mike Herman at H&H flatheads? I have some questions regarding building an engine.
still for sale
I went right to Summit but found nothing in the search '- have a page # or description to type in?
I am trying to find comparable sizes of radial tires which would equal a 6:00 x 16" and a 7:00 x 16" bias ply tire that will eventually end up on...
Seems somewhat weird at this point: 2 years ago when I bought my 7:00 x 16" tires for my A, Coker told me That once they were mounted to my...
Ok, another approach to the same situation..... Go ahead and modify the spring hangers to suit your needs @ 3/4" +/- , and then, rather than cut...
So far, the closest shop is John Warden in Iowa - about 6+ hours away :confused: probably where I will end up and spend the night too!
Reading through some of the "old posts" and following up, I find that most of the people/shops that still have current phone numbers will refuse...
Hello; in an effort to help those who have unsuccessfully tried to find someone to shave their bias-ply tires into a somewhat round & drivable...
Visually, I can see what is going on with the complete roof & rear panel section removed in one piece, but could you "explain" the benefit of...
Fantastic ideas and solutions to a simple problem. For now the best direction will be the stainless tube reducer from Fillerneck Supply and then...
I have a B' engine in my 31 A, and the outlet from the pump is 2" going into the top tank of a stock radiator. Here is my situation: for me to...
Price lowered to $4600 as of 4-18
My rebuilder and I are looking for either a blueprint for an 8ba torque plate, or the possibility of renting one from someone so we can finish the...
For those of you who have done this and know something about V8 flatheads, I am asking for help with your experience & knowledge on this subject....
All auto manufacturers used the "flash" chrome process up through the early 70s because of the low nickle content of the materials and also - they...
Separate names with a comma.
The Jalopy Journal
