The Jalopy Journal
Gorgeous! Love the tags.
You learn well Grasshopper!
Not the best pic. Drake has the top mount basically through the place in the crossmember where the exhaust pipe goes, that little cutout. Not a...
I put the taper [ATTACH] shim on the inside.
I intend to put a tapered washer on the inside. Thanks for the input. Bill
I'm installing a Bob Drake rear shock sway bar in my '39 Tudor. The upper crossmember, where the shock mounts, does not seem vertical so the...
Thanks for the update. I know all to well being overwhelmed. I am at that point. I get something partially done then see where I can't finish that...
Bruce helped me a couple of times. I always knew when his name was on a reply it was good information!
I ride a bicycle most days, anywhere from 15 to 25 miles, weather permitting. I use an elliptical for about 40 minutes a day in the winter, 72 here.
Thanks. I stopped by your spots a couple of times Thursday but you were out and about. I bought the '39 bumper brackets from you at your shop. Bill
My old T was pretty reliable. Failed me twice. Both were right at home. Once blown ignition module. And once the rubber fuel line from the tank to...
You have learned very well! I hope to see in person.
Gorgeous in everyway!
I know that this thread is 2 years old but with no response to the question I thought maybe some one has tried since. I am considering the...
I know this quote is 2 years old but maybe someone has tried the brakes since. I am considering them. Several other companies sell them as well. I...
Front and rear bumper brackets for my '39 Ford Tudor.
Thinking of it. Walking and looking. Went to Carlisle last year and found what I wanted so I didn't go to Hershey. Probably Thursday or Friday....
I know this will vary but how much was the sand blasting?
Mine was satin black. Never should have sold it.
PA it is designated as a Street Rod. The year is the year it was titled, after inspection. Selling can be a pain because some states will require...
I bought a 1939 Ford project with an 8CM in it. It has an electric fuel pump. An oil breather/fill tube is in place of the original fuel pump,...
Too slow, spring is gone from post and it was recently edited. It was there I saw it. Thanks I should have jumped on it.
Thanks for catching that but it actually says not for fuel injection. I went out and checked. However I did change the fuel line. Their was about...
The black hose is the fuel line. Working on how to setup the PCV. There are quite a few threads on this site. I just need to find one that works...
I considered that. It might work.
Oooops! I should have mentioned I am looking for a stock spring. The car is a project that came with a Posie's reverse eye spring. I prefer a rake...
[ATTACH] New to flatheads. Mercury 8CM what are the 2 holes/passages in the manifold for? I tried searching and couldn't find out. I must have...
That was another thought. I've seen pictures using copper and also steel lines at the carbs. I believe the 97s can use a compression fitting. I'm...
[ATTACH] I currently have the fuel line to the dual 97s as above. I am concerned about engine heat causing problems with the fuel block where it...
New to flatheads and dual carbs really. I am setting up the dual carbs on a project I bought. I have seen the linkage on dual 97s with the linkage...
Separate names with a comma.
The Jalopy Journal
