The Jalopy Journal
Since you have to pull the engine either way.
Take the flathead apart and see whats wrong with it before deciding.
Miller XMT 304 welder with LN25 wire box.
Use .035 for short arc and .045 for spray.
30A spool gun for aluminum.
180 SD syncrowave for tig on...
A stock model A axle has a 1' drop from the factory.
Tire size, wheel size, weight of the engine, stock or reverse eyed front spring plus other...
Po Go stick ?
So how did Detroit break in all the new car engines before selling them to customers ? I don't remember a lot of engine failures in new cars.
You would never get enough altitude for the chute to open and be able to land. In a jet fighter , you only have to clear the plane and have...
The first thing I would do is level the frame either by using blocks under the wheels or as I prefer, jacking the frame up on all four corners....
Since cracks seem to come up when ever a flathead is mentioned. What causes a flathead to crack ?
I would hate to spend $3-4,000 on a flathead...
Can't help with any later model ford engine info.
I was at a guys house out in the country buying some 35 Ford wire wheels and he had about twenty...
I know everyone likes chrome but you would be ahead in the long run with a kit like this. Look at the bottom of page for the expensive chrome...
Do you have the maid come in and dust once a week ? :rolleyes:
52" to 53"
'28 to '40 Ford
'57-'59 Ford and Edsel
'63 to '65 Fairlane
'65 to '66 Mustang
'62 Buick Skylark
'67 to '70...
Now that he won a trophy, he had to upgrade his picture.
I stop and look at the cars that catch my attention and could care less if they drove it or it came on a trailer.
I paid $200.00 for these valve covers and they threw the engine in for free.
looks like ackermann is way off.
I'm guessing that if you live in a industrial area, you're probably breaking some law.
Good question but the scrub radius would change as Ford went from 21" wheels to 16" wheels through out the years assuming he used the same camber...
Off subject a little but it appears that your scrub line is too low by the picture but it's hard to tell from the front.
You can reduce your...
Apparently the homeless tents and bicycles all over the streets in California aren't as much of a problem as peoples cars. Personally I'd rather...
Probably be listed on Ebay by the weekend.
Perhaps it would be a good idea to ask the fellows at the photo shop thread to put together some samples before you spend any money.
We used this stuff on hydraulic and air cylinders in the paper mill I worked in. Bead blast the grove to clean and hone after it set up. Pulled...
In Washington State, the X signifies a passenger car.
Copper sheetmetal, copper nail and a broom stick handle. Backing for sheetmetal welding.
30 splash aprons will not fit a 31 fender. The 30 fender has half of the splash apron attached to it. It is basically a two piece splash apron....
A lot of detail with pictures.
Separate names with a comma.