The Jalopy Journal
Ok, I give it a try without the 10 ohm resistor. Will see what happens.
Ok , Thank you
Yes it has, I have the same wire diagram. I just was wondering how the set up with the 10 ohm resistor is
Thanks Jim. I was looking at something like this too, just was wondering about the small wire.
I know some in the H A M B group did an generator to alternator conversion. My alternator and most of the wire are installed. My question is what...
I looks like 1/2"NF , but every Nut I bought does not fit
[ATTACH] What seize is the Power Steering Pump Pulley Nut? I lost mine and I can't find any information on the internet. Our local part stores in...
You are correct, there is a little noise. I bought a Edelbrock pump almost no noise. All my old cars have a electric pump. Fist help to start the...
I have to check it. Thanks
How does it work. I never saw a inertia type before
I have a 1959 Buick with an 364 engine. I bought a eclectic fuel pump and I am in process to install the pump. I know I should install a oil...
Thanks for the advice, everyone.
Ok, I have a question. AGAIN.
I replaced the engine in my 59 Bel Air with a 350 engine and a HEI distributor. What would be the best way to...
Does anybody has the Small Block Chevy torque Engine Specifications for the
motor mounts to engine
motor mounts to frame
motor mounts to motor...
Ok , I will order a new Flex plate. But First I will take out the engine. I believe junkers72 is right about the staggered hole from the oem...
Thanks for the information
Thanks again for all the help
, I always try not to buy made in China Taiwan......
So I can use 153 tooth or 168 tooth?
Thanks Jim. when I checked the internet I saw they have some with 15X teeth and same with 168 tooth .So I need the 168 tooth correct?
Thanks Ray. The summer is not over so I still drive my Belair.and can not compare. But this would be my second choice
I am replacing the power glide transmission on my 59 Chevy with a TH350 tranny. I have everything together but would like to know I have to...
I belief it was 340281 not 100% sure.
And exactly this is what I like to get rid off , the old crankcase venting
I have an original 1959 Bel Air 283 engine 350 TH transmission. I will not use the car for racing or so.. Just like to have an nice...
Yes it is funny what GM did. In Europe you could by big Opel cars with brand new 327 engines up to the 80's
Thanks for your answers. So is it a good intake or should I look for a late 70's early 80's intake. I do not need more power. I only want to...
Separate names with a comma.