The Jalopy Journal
Second day down here in Texas, too.......headquarters for Atomic Industries! DD
Yup, it DOES work! As above.......absolutely NO lube on axle, or inside hub........CLEAN and dry! Tighten nut to spec. The tightness of the nut...
Correct......the Jeep tailshaft housing is only 6" long. That is right at ~ 10" shorter than a 2-WD S-10 transmission, and that's about as short...
I know this is an ancient thread, but I have reason to be playing with these Jeep T5s at the moment, and I have some info to add that will...
Many DC motors WILL run backwards by reversing polarity...like window motors and seat motors.
Your Starter Motor is a series wound...
Any good news about Dick from anyone? DD
Tried to watch it last night and it turned-out to be some good lookin' gal driving a city bus like a mad woman. DD
My God, good heads (in better overall condition) are almost a dime-a-dozen. You've already done the hardest part in removing the boogered head. DD
A pic that I came across some time back. DD
[IMG] What ya got against square airplanes? DD
The Ford "stamp" is not an "atta-boy" from Ford as to design and quality. It's an expensive licensing agreement permitting the reference to, and...
That sure doesn't look like any "1935 Henry Ford Steel 3 window" to me. Looks like a Chevy body. DD
Quite representative of the way GM did frames, at least back in the '50s and '60s. Corvettes had a similar type of stenciled application on their...
If it was still sittin' in Dean's garage all these years, Dean would have it in the front yard washin' it and it would look more like...
Essentially a 2.5 to 1 ratio, given the above figures. DD
Dash is different. Of course, taillights differ. '40 has column shifter vs '39 floor shifter. Clutch linkage as well as pedals was different....
Yup, Greg dropped it. Click link for his web site. DD
Really nice ol' car. Don't guess anyone near-by owns a lawn mower, huh? DD
Usable thread length should equal AT LEAST the diameter........in this case, 5/8" +. I believe I'd look for another axle. DD
Right here! DD
Weird, huh? True scoop! DD
The "infamous" Moriarity unit. DD
I believe you'll increase the force by 33.3%...not 25%. DD
Before you go to all that 4-bar stuff, is there any way you could modify or change pans along with using the pictured '49-'51 Mercury U-shaped...
Yes this is an old thread, but the front wheels/tires on a '40 have "appeared" to be in the wrong place in the fender opening for nearly 75 years....
One, short trip! DD
RICH B...To try to answer your question, I just went out and fondled one of those pins. The shank is fully ROUND...no slots. It is similar in...
V8-60 pins! DD
Early Mustangs never had a frame as such. I'd look toward a Chevy Nova. DD
NO, but is is POSSIBLE that the M/C has too LARGE of a bore for the calipers, and even the rear wheel cylinders.
SMALLER the M/C bore equals...
Separate names with a comma.