The Jalopy Journal
My rule is electrical tools..worth it, from HF. Had a dremel copy for almost 15 years.. Used a 4" angle grinder at work for 4 years..Usually the...
Got a 100 psi in my head right now! Put the valve cover back on! Tape over all breathers. Tape the carb flange..Tape the exhaust port ..Plug in...
How do you like those East Coast sea level tracks? ;-)
Mr. Wes Perkins..Later, had Camaros..Worked for D&D in Bristol for a while, then had his own machine shop Small Block Engineering. ..Last seen,...
N.E Dragway's version of Jr. Stock.. Kind of a homogulated ( new word) version of AHRA and track rules/ records. I think this is Professor Vic Santos.
What size 2G carbs?
Actually, they have for a long time, JS. I raced two different 1964 220 combos in the 70's.;)
Seeing 283's didn't come with Qjets..I'd say .073 jets are too big...069 to .071 would be better, IMO
Can't help with AFR numbers, etc., but .125 at lowest point is probably too high. ....187 range probably better for a non- race car.
I was able to contact the club rep. and he's going to help me further.
Thank you... HAMB Power!
I hear ya, but I've got to have permission to stay in case it turns out to not be a simple fix.
26' with a 12' m/c trailer.. Not going near the pass north of Mono Lake though.That's what killed it the first time!
Mammoth Lakes..Right now, I just need some flat pavement to jack up my RV on to work on a valve body and maybe stay a couple of days. Preferably...
Thank you..Trying to make contact.
Number has been disconnected ? Thanks any way..Keep it going...Bump
All downhill from there, almost. Check out the railroad loop , coming down the hill. One more pass on I 15 before the state line..Shouldn't be...
Only is they're good and stuck. Gotta get it out some way. Then smooth then off. Should just about fall back in.
I'd worry more about the...
How about Big Pine? Lone Pine?.....Ridgecrest?
Jim, Congrats. Have you planned your route back to SV?
How about Lee Vining, Bridgeport??
Yes. You have to pull the v/b and start at the 1-2 shift valve. Pull the spring and then see if you can move the valve easily with a seal pick....
Got a bit of a road side repair going on here. Probably could use a little help.
Thanks in advance. MY
PM or 602 769 0346
I'll take Stuck Valve for $100, Alex.
Anything else,..you'd get a "neutral " or flare up on the shift. 1-2 shift valve is where I'd look...
Previewed in Vegas:eek::eek:
Mico Lock and Park ..What more do you need?
Glad someone told you you don't need a Gear Vendors.;)
If that's correct, that's not too bad at 60 mph. It would be great to run 65 without tearin' it up, so you could average a mile a minute.
Why the TH400 and aftermarket o/d? Why not use a 200 4 R or a 700R4 o/d, if I might ask.
We've seen SBC's installed in everything under the sun. I don't think this one would be much of a challenge.
Also, I don't believe the frames in...
Seems like that car would pull 4.11's with the torque they have. What's the O/D ratio? Can you run 65 now?
Separate names with a comma.