The Jalopy Journal
My new favorite is keystone rt44 from NY state line all the way down to Williamsport, PA. It is about 100 mile, 5 towns, and endless state and...
model A and early 32
So, I called HRW and they have the parts I need to assemble. Nick at HRW said he has assembled on of these recently and it worked out OK. Sounds...
I went back and measured again, it is 3-1/2". I guess I shouldn't rely on pictures of tape measures.
here is the measurement of the lower shaft
Al, where are you in NY?
Is it possible to cut down the V8 ring gear and carrier to fit inside, then use V8 Pinion, with Model A Axle tubes?
What is the OD of...
9" bolt pattern
Oh yeah, V-8 axle bells do not fit the QC housing either.
So, Folks what we are looking at seems to be an oddity. It is clearly a Quick Change and I am glad to own it.
Everything points that this is a V8...
Well gents, I have had this Quick Change housing hanging on the wall in my shop for nearly 10 years now. It is a little bit of a stumper, as no...
cleared reserve at 25K, it is going to a new owner.
Kohler Kustoms awesome 41 Ford is on the dreaded auction website.
This is a one of a kind truck, hate to see it go....
never seen them before other than GM products
I love the Chevy hood sides on the Victoria
Thought I would share information about an upcoming auction in Ellicottville, NY, A few nice early Ford cars going on auction. I wish I had some...
I always loved Doc's racing Turtle
be cautious here. I see you are using the stock A gas tank. I used Stewart Warner mechanical gauges in the left and right holes. The stem off the...
Oldslite? Olds? That doesn't make sense, I have never seen any reference for Olds to have the center reflector as this one shows.
while were talking about BOB K, who is the last one to see the GNOME??? who has it??
He was actually playing with the idea that he was "ICE FISHING". Only thing that says he was not ICE fishing is the fact he is shirtless and...
The OP stated that he was new to hot rods, he was also looking for ways of doing something. Yeah your way works also. The spreader bar works also....
I usually would unbolt spring from frame, undo the center bolt and did-assemble the spring pack. Place shackle on one side of primary spring and...
I have a 40 project at home and I recently dragged this home
With a little slicing and dicing, wonder if it is possible.
Anyone know where I can see some pictures of the 40 truck with 38 deluxe front end on it?
Here is an older thread
my understanding is that they work like the clutch in your car. they have a pressure plate, flywheel and a clutch plate. Apply the brakes and the...
if you can afford a little verticle height under the hood, I would recomen one of the best performing intakes. The Edlebrock Slingshot is a very...
picture from the WEB of a FatMan front axle kit[ATTACH]
Anyone know anything about the "Bellamy Ford Axle"? Was this an actual Ford axle for European sales?
Separate names with a comma.