The Jalopy Journal
this is completely off topic,but since you guys have all kinds of weird old engines i thought you may know of a Waukesha ICK parts stash.
turn the fan around.
nice car Guy...
The International 345 engine used an extended nose like that,it had a 2 bolt flange mount.
the Mercruiser engines had one like it too.
I would be...
Where i had head gasket problems was where the lifter area and the water jacket dividing wall is,the wall is very narrow and i would get water in...
I have a 4 shooter Rons fuel injection setup,for sale cheap.
I have a new (10 years old) superT10 that i ran in my speedracer.
I had Tex racing build it,they were a builder for NASCAR.
It has 2-3 runs down...
The converters will be different for sure.
Take the belt off of the alternator and try it.
i had a manifold like that once,mine was a Moon and took weber carbs.
I got a lot of money for it too,about 30 years ago.
drill a small hole in the carrier at the blind end of the broken bolt and use your air gun to blow it out,by blowing in the small hole you drilled.
Change the pulley to a machined pulley,not the stamped tin one you have.
The tin pulley gets hot when the belt slips and spreads,the angles change...
The trannys thisalator may be stuck?
i have some drop tanks in SW Ga for sale.
And,i have a Maxton record holding comp coupe,57 fiat for sale too.
No engine,but it has a new super...
I have several 500 and 472s for sale,i even have a stick shift flywheel.
all located in SW Ga.
i have been twice in the last 5 years,driving a very expensive motorhome,towing a jeep.
No damage,just drive slower than the speed limit and you...
it looks pretty good,and if you need him Jamie Frankland still does some work on thise old rears.
Hes at Frankland Welding,in Balm Fl.
i set my timing by ear=i am an idiot.
i have several 500ci and 472 ci Cadillac engines and paers for sale.
5 engines total
New set of Potter roller rockers with push rods
i have a couple of those engines,and a standard flywheel and a new set of roller rockers,and an alum intake.
I really should sell all that stuff.
nope,those tanks were used to hook sea mines by the cable and pull them up.
they had a hook on them,a big yoke and fins,they were towed behind a ship.
The tool is a spark tester,spark plug wire goes on the screw head,there should be an alligator clip on it,the gater clip clips onto the engine....
Great job,i read all your posts and i think its awesome.
too bad i don't need a block.
i sold the 534 i had,but have another if someone wants one.
Complete engine,all accessories and an allison transmission.
its in a 1972 Wanderlodge...
The engine i blew was my own fault.
I narrow the rod bearings up in my engines,and i put a chamfer on both sides.
On the destroked crank the #4...
i have a set of anglia spindles with disc brakes and calipers.
Bought them for my speed racer and never used them,
They are used,in good shape.
i have a brownie box,a 3 speed,one gear underdrive,then direct,then one gear overdrive.
Rebuilt about 10,000 miles ago,i have driveshaft yokes and...
hey guys,i'm still alive.
i did loose interest in running the mercruiser engine,and i did spend 10 years building my warehouse home.
cash flow has...
Separate names with a comma.