The Jalopy Journal
Thanks to all.
Hey Guys, I need a measurement from the block of a sbc to the end of the pulley off the crankshaft, for a 3" belt, so I can my motor...
I have there long 4 bbl. intake, Headers, Valve cover.
Very well made, good service, and yes I would buy from them agine.
Here is couple of shots , more to follow.
Hey Guys, just to let you know I lowered the pinion 4* and it seems that all is well.
Thank You all for your help.....Mike
I will lower the pinion and put a shim under the trans. and see what happens.
Thanks to everyone who helped....Mike.
[ATTACH] I hope this helps, also its on a 4 bar link with coilovers...Thanks
when I measure my shaft its 5* up hill.
My shaft goes up hill to the pinion ? does that mater
This has been like this since day one
I know by looking that the rear joint is on more of an angle than the front u joint
I Don't know how to do this, could someone tell me how..thanks
Hey Guys...I have a driveline vibration for a couple years now, that won't go away, let me tell you what going on. 1938 Plymouth coupe, slant six,...
If you want to get it right the first time, do this...Know your piston size on your calipers and your brake pedal ratio and call wilwood tech....
I have two '38 Plymouth coupes, one has a slant six, I used electric fan from Summit racing fits perfect in front of Rad SUM-G4860 16" 225watt....
I am so sorry to here this, my condolences to his family and his friends.
I have the same set up on my car..Had some problems, I changed the pedal to a 6.1 ratio and put a 15/16 bore master in. now she will stop on a...
Hi...I had the same thing, had a vibration when my foot was on the gas up to 2500rpm. take foot off the gas and the vibration went away, so I...
I see that you have a tilt front end, I like that. I have a 38 Plymouth that I would like to have one, Did you just weld the panels together ?...
Hi Guys.....I need some help my steering, 38 Plymouth stock axle with disc brake kit. Need to replace steering box due to wore out & I would like...
Over the years, I have tried a lot of different ways to heat my two car garage. I broke down and bought a small house furnace powered by gas, Yes...
Yes...I will PM you as soon as, I can find out how to PM someone
O/T was it you that put a Willys front on a Plymouth coupe ? If so was that a hard job ? I have a '38 Plymouth coupe that I would like to try...
I have a '38 Plymouth, 4 wheel disc none power, I had a problem so I called Willwood Tech. gave them piston size and pedal ratio, change my pedal...
Thanks guys for all your help
Thanks everyone for your help
Thank You Sir...its off. Also how does the rear section come off, I want to total take this columu apart, Thanks
I have '38 Plymouth coupe with an straight axle, push and pull steering box, its time to change the box as its wore out, I want to go to...
Separate names with a comma.