The Jalopy Journal
glue screws to a screwdriver tip in awkward places. can't get a nut on a bolt in a tight place, glue the nut to your finger tip and screw the bolt...
I used a drop fold panel from a 90's Ford Taurus. Mounted on pass. side, away from traffic. All you could see was the "pull" handle.
I used a '70 Torino for my rear. was a perfect fit. tires are about 1" from the inner fender lip.
yes, it sounds like mid 70's Torino wagon with taper brgs.
I found a pic on the internet of a mustang with the same manifold and there should be a tube exiting out the bottom to feed air up thru the stove....
Decided to hook up the auto choke on my carb (SBF/ 2 brl). I cleaned out the hole in the exhaust manifold so the heat tube would slide in and...
my '41 was not syncro 1st. gear.
I used a banjo bolts and flex lines from speedway. they have different lengths and they cleared everything
go to McMaster-Carr and find a moly impregnated nylon 6/6 bushing. It will last a lifetime
..and there are parameters on how many turns of tape to apply to the threads, depending on the pipe size.
Ditto on this but don't go too far back, as in '41/'42 as the running boards made the rear fenders longer, in front, where they went to the...
rustoleum makes a spray- on coating that protects the paint. it can be peeled off to renew and is clear
McMaster Carr supply
I have C41-8cw on my '41. everyone thinks it means circa 41- 8 cylinder windsor but it was just how the plate no's were issued.
a lesson to be learned. make everything accessible. what ever can go wrong will!
melt it closed with some plastic/soldering iron from the edge of a flange. I drilled a hole by mistake in mine and ran a sheet metal screw in to...
It's amazing whet you can see in a photo that your eye can not pick up. also in a photo you can compare both sides which is pretty near impossible...
make sure M/C piston retracts/stays enough to clear the port in the bottom of the resevoir
no rust body/frame, new body to frame rubber mounts, stock front suspension w/ disc, '70 ford Torino 2:75 rear w/C.E. springs. 302 -2V, new...
had same problem with my alignment shop. went on google and found the specs. and they went by that.
get back in the back seat!
sounds like too much toe out.
doesn't PertroniX make a 6V flatty conversion?
Corvette, believe 1". dual 8" booster
try mcmaster-carr supply
tried all the above. thinking maybe smaller M/C bore
adjusted rears until they drag slightly
does exactly that
removed prop. valve as I couldn't see any difference adj. all the way in either direction. I have a metering valve ( disc hold off valve) in the...
Separate names with a comma.