The Jalopy Journal
If the system has been a part did you Polarize it at the regulator?
The Chinese kid who made"m did the best he could........
Box the rail for 10 inches on each side.
If it takes side engine mounts rule out 1957.
Back seat from a Dodge Caravan.They fit,and appear to mount low.
Any chance it has had modern oil put in during the getting it going effort? If you didnt add Zinc it may have a flat tappet now.
Could well be it was a Aus car.If you come this far you might as well see the country.Wish I had the time to stop,and look.
Going cross town in N Calif this afternoon,and saw a parked 29 roadster PU with a flattie in it.It was pure HAMB stuff no late model shiny stuff...
Someone on E bay offered the service.Check under S10 T5 trans.
Recall as a kid in the mid 60"s Chrysler had a contest for a give away 426 Hemi engine.Some kind of fill out the coupon,and mail it in drawing.A...
My buddy when I was a kid built a 37 Chevy 1/2.He ran a 327 backed by a floor shift 3speed,and a Pontiac rearend.He put 49-54 Chevy car...
Are you using new drums,or older drums turned to max. dia.? Their going to react to heat up differently.
Something early say 57-60?
Also check you hinge pins/bushings for slop.
Check all your cab mounts.Something may be sagging causing gaps to close.
Im guessing its 1965 Mustang parts which use 154 brakes.Have you used a new drum for one?Im wondering if the builder used Mustang spindles,and...
Its short notice,but the Iola Wi. car show is coming up.Great place to have a information booth about whats going on.If a few thousand car show...
57 rear housing has a drain plug bottom center.55-56 do not.
Not everyone can afford a 32 Ford.
Find a title service ,and have them get a title.You might also be able to file a lien sale to get title.Tow companies do it a lot.
Did you check how it turned one rod at a time?You might only have one out of spec doing it.If it starts turning hard with one,and gets worse then...
Chevy PU"s offered it in the early 80"s.Dont recall seeing it much later than that.
If the end has a inverted cone,and the cylinder has a cone then Doublepumper is right.Self sealing.
Mac"s Early Ford parts lists a shaft with gear for 61-64 for 297 bucks.Its the most fool proof short of a different box from a parts truck.
How many times did the stock split in the last 116 years.......
Lucky find.Rust free too.
If you chopped the top a lot of those small pin holes would be gone.They repo the roof area over the doors.If the curve is the same as the rear...
With a pair of doors you could build a cabriolet.Ive seen guys start with less.
Separate names with a comma.