The Jalopy Journal
Had to grind the cap for clearance on my Fenton tri-power. D
Crap! you made me lose count..........D
I have in the past put a tube in and used it to seat the bead. You can then break it down on one side and pull the tube out. Not the easiest but...
You may want to think about putting some stops on your brake and clutch pedal to keep the rods in place if the pedals are lifted up. D
Maybe some sort of a bellcrank device?
I went two years ago and was used to doing a lot of walking. I rented a scooter for the second day I was there. That was a first for me, but there...
Running one on my car. Nice "kick" when you open the end carbs. D[ATTACH]
Had to modify the fender braces on mine to get it to work. D
Got about 90 miles in today. D[ATTACH]
How much "taller" is the five speed compared to the Muncie? D
[ATTACH] I cut the AN off of this frame pass through fitting and tapped it to take a pipe thread. D
Stick a flat blade between them and push down on the lower one and it will release the spring pressure on the upper and it should come out. The...
Look at some motorcycle parts sites. D
I am running this for my heater. Not really three distinct speeds, but it is...
Totally Stainless has 'em. D
56 or 57 Ford IIRC, D
Good question. I have never had to do this as my Muncie's never gave me a fit like you are having. I would start off with maybe three flat washers...
Maybe try loosen the tranny bolts and pull the trans back from the bell. Even space it with washers to see if it lets the driveshaft turn. This...
I sure am glad to find out I'm not the only one with this problem. Maybe we could come up with a steering wheel exchange program? D
Did you ever get this sorted out? D
Isn't that what the hook goes into on the hood side? D
Just keep dickin' with it and it will all come together. Be sure and write the part numbers of what you end up with down somewhere, LOL. D
I wonder if the thickness of the Ford disc is more than the chevy disc for that application. If the Ford is thicker, then the fingers will pull...
I was concerned about the lip that was bent. Could be the camera angle. D
85 and up are a little new for me. I used components for mid sixtys stuff on mine. D
Center the brg in the fork and make sure the tail of that rivet isn't going to catch the edge of the t/o brg.
Put a small dab of wheel brg. grease on the end of your pivot ball before you install the fork in the bell. In the picture of your pressure plate,...
I did have a fork and a brg. though! That rivet for the spring looks a tad long on the brg side also. D[ATTACH]
T/O brg. doesn't go on the fork like that. Someone will post a picture on how it goes. I don't have any pics that I know of. D
How hard did you pry on the fork? Was it in the direction that it is bent? D
Separate names with a comma.