The Jalopy Journal
Harbor Freight has an assortment kit for 1/4 inch drive that has 3 sizes clutch heads bits. I use them taking 46 Chevy cab apart but will be using...
Always liked this one, liked it better in Brandywine though.
Thanks for bringing these over , I not smart enough
OK I found some here on the Traditional Customs. Stray Kats' "Kustom Blues? I need to see some". Page 362 about 6 from top post #10836. Sorry I...
finished I'll see if I can get pictures up !
The grill pattern is'nt all that pleasing to look at but the chrome grill surround is nice. Not sure what it came from but it is a little...
I'm pretty sure Jim Carter has those
You are correct, it sucks gett'n old and forgetting important stuff. my bad !
That top is correct for that car . The guy with the white whiskers is Bob Brauch who built the car, it went south and was destroyed in hurricane...
busy in shop, will try to get some pictures on here before we go to SK500.
You mentioned reading 6 volts everywhere with your multi-meter.That should be correct. You will need to go to the "amp scale" and open the...
Any old big truck (Mack, Freightliner, ect.) with quad lights will have the headlights you are wanting.
Got my engine/tranny back yesterday.Bought a totaled GM with LS engine, had the harness trimmed ,computer reprogrammed , and sending unit holes...
Atomic Kustom is correct
on the coupe, sport coupe and converts. Fords used the longer panel between deck lid and roof .
I have seen beauty rings attached to the hub cap , but you will still need a deep rim .
When you were replacing pilot bearing did you look at surface of flywheel & pressure plate ? Springs in that "new" clutch might be week also .
Can't wait to see this one done , don't see 57s chopped very often , looks great .
Check for crack in frame at first body mount especial on passenger side , and for rot from there back . In other words you gon'a have to get under...
First week of retirement , I'm back at it !!
Most of the names I've called my vehicles have involved bloody knuckles and shouldn't be repeated.
Check'n the anti freeze and pack'n some long handles .
Not sure, I don't like anyone anyway !
On the back of these cabs at the belt line there is an over lap. Was this done to allow flex, to ease manufacturing or just to make a place to...
Welcome from Missouri , was working in Braggs today.
You got air in your lines.
I saw a white one like that in the movie car museum in Branson yesturday. It was a Cadilac,I think, but I can't recall what it was called.
Separate names with a comma.