The Jalopy Journal
More than likely just needle and seat is contaminated.
If you haven't tried this, drain the fuel blow and then refill, it lets the needle drop...
yes, 94's have been a challenge in multiples installations.
it has to do with the low speed signals to the fuel metering.
I rather like...
Antique Nationals 2019 has been cancelled due to rain.
No 2019 rain date scheduled, it looks like 2020 is the next one.
HA! had you fooled!!
No, when we start to think we know it all we have lost the ability to learn.
Trust me, I learn new things every day,...
I know that I don't know all, but I have seen a thing or two.
Copper plug indexing washers come in a couple different thicknesses and I have used...
Not an original Winfield? it looks too clean
Both plugs will work
If you can find some Plug indexing washers you can run the 3/4"easily
The 1/2" looks too short, could also have the plug...
A couple thoughts on bottom ends, motor, not yours.
If intending to drive the car at higher speeds, you are going to need to have the bearings...
At this rate, the Coupe should be doing 9's in the 1/4!!!!!!
Damn, it was just February, wasn't it?
count me in
Saturday morning coffee meet[ATTACH]
Very cool build, keep the pics coming.
It is scary what we find in the bottoms of these motors. Not to mention the tops too!!
If it doesn't work, ship it to me for testing, I should be able to evaluate for about 7 to 8 months...........
typically what you are describing is a lean condition
it is a balancing act between accelerator pump, jetting and temp
do you have a thermostat...
Sorry to hear that, at some point it would have been easier to get the raw castings and chase machining.
Had enough rain here, checked in
Its all good, I respect your innovation and engineering.
Afterall, anyone can copy someone else.
I am not sure the coffee table has to hold it, just put a big sheet of glass on top of it!
I was looking at it and it just made no sense, only...
OK, what's wrong with this motor listing?...
I think the device laying in the early photos is the fuel pump for the injection.
The pic above with the red circle shows the FI pump just below...
In any club or volunteer event 90% of the work is done by 10% of the people.
Ron and Carol have done a fantastic job with the FAST publication.
They have also been working on the Antique Nationals for some years now.
Yup, I see what you are saying, my bad. I knew something didn't look right to me.
Incredible pics, Smokey was ingenious no doubt.
It looks like both pics depict attempts at different approaches. What looks strange to me is that...
I hear rumors of a TROG in Cali soon, not seen any adverts, When and Where?
Honestly, I wouldn't complain about the "lack of quality" this one looks pretty good compared to some.
You could do some work in there but the...
and I am told that I am too selective...........
I look all the time at blocks, very seldom does one go home with me, even less leave here.
stock Model A is a positive ground system, check the battery, which post is on the ground strap.
Had a block in the shop once, owner was real proud if it, told me it is fine, has been magnafluxed.
When I showed him the cracks I had to explain...
Separate names with a comma.