'36 Chevy 5w coupe measurement needed

Guys, I need to know the door opening measurement to put a new rocker panel in place. The shell I have is completely without metal where the original was - mother earth reclaimed everything from the bottom up about 5 inches and the doors are also just skins (lotsa work ahead there, too). Any help would be appreciated.

 

Post a picture of where or what you need I have a 36 5 window master in the shop & making new hand formed steel front fender plus new Heidts front suspension.

 

carbuilder - pm sent

 

I will be back out in the shop Tuesday I will get them for you.

 

and the wood is gone too? Remember there was a 2" X 4" (or there abouts) hardwood piece that tied all of it together. The rocker was nailed to the wood (might have been screwed to it) and spotted to the jamb which was nailed to the rear jam wood.....

 

Yes, all wood is gone - doors are just skins. Hope to do a steel replacement.

 

Vintage 44
at the bottom side of the belt line 40 1/8 inches
at the lower door hinge bottom parallel back 42 inches
hope that helps

 

Much obliged, carbuilder. It's a start - thanks.

 

Let me know if you need any thing else I will have this car here for about 3 more months I am making new front fenders from scratch the ones on it are super thin ground on to many times & very holy I an not talking religious either.