Reference for a '32 Ford 5 Window.

Thanks for your information Rexrogers =)

 

I'm still waiting for wbrw32 to inform me where i'm wrong ??? Looks the same to me!

 

Looks like the same to me to..... But I wonder how the water from the side profiles is supposed to be drained.

 

Need to know the original size of the trunk lid handle hole as mine is trashed, also a measurement from lower edge to center hole. No rumble.
Anyone ?

 

Hole is 31/32 of an inch

And 1 11/16 bottom to center

Measurements taken from a Brookville decklid

Mike

 

Here's a few pictures

The notch on the left side of the hole measures 3/16 by 11/32

 

I could some help with a measurement on the rear rail. See the attached pictures

This are has been cut and is too narrow.

Thanks

Mike

 

I can get the width in the morning, if nobody knows right now.

 

Mine apears to be 1"

 

Thanks Mike, just did it. Next up weld it in

I check my rear frame to to see if it is an inch. Back in a few.

 

It is probably norrowed to clear the tank, thats what I had to do. Mine is 0.800" wide at the thinnest .

 

my original 32 frame is 7/8" wide at the top flange, and 1" at the bottom flange. It does not look like it was modified from staring at it pretty closely. It is not the early 32 frame that was not re-inforced above the rear axle tubes, if that matters.

 

Thanks guys , yup mine has been cut to clear the tank

I appreciate the help

Mike

Oh and Martin

You have way to many cool tools ! And worst yet you are a master a using them all!

 

Jeff this IS good reference material!

 

Love seeing a 5 window going back together, looking great.

 

...

 

B pillar wood question.

I just recieved my wood kit and doing some preliminary fitting. The wood sticks out about 1/4" from the B pillar channel. Its even top to bottom with no one thing holding it out. Should it fit flush?

 

I think it is as it should with the 1/4 inch stickin out.

 

Great pic´s Jeff !

 

Dear Friends .
Im working on the inner window trim trying to get it fit proropertly.
I have no idea of how the screws should look for the top of door garnish moldings.
Booth door and molding has 1/4 holes.

In the bottom there is wood in the door so the svrews have something to attach to.

Anyone with any idea how ?

Cheers Martin

 

They use what they call a tube nut on them. You can probably find a pic on Drakes or Macs website. HTH Dennis D

 

Thanks Dennis, think I found at Mac's :
http://macsautoparts.com/early-v8-f...w-frames-a48222/camid/F30/cp/JS0R3CHL1129805/