best Vega box mounting bracket for 32 frame

Ive got a 32 frame from Squeek for my 29 Tudor and looking for the best mounting bracket for a Vega box. Most of the ones Ive seen in catalogs dont look strong enough. Thought Id try here for some help. Any advise would be greatly appreciated. Below is a pic where Im at so far.My friend Sam ( SamIam ) is giving me a hand with the build. Its running a 327 with 3 deuces, turbo 350 transmission, Ford 9in rear end, 35 Ford wires with 7.50 16' out back 5.50 16" up front, exhaust manifold off an early Corvette so I can mount a generator. Mild 3" chop and body on top of the rails. Interior 35 Ford dash w/ early Stewart Warner guages for the important stuff and an old speedo out of a F-1 pick up. Seats are buckets out of an early T-bird. Lookin forward to posting pix here of the build as it goes.

 

Pete & Jake's makes the best one I've used (dozens of them). Don't use the one Speedway sells.

 

yes , Pete & Jakes is good

 

Make one.

 

yes , they are easy to make. i bought one Pete& Jake's bracket and have copied it many times

 

I agree with making one too as others have said but i also really like the chassis engineering inc. mount part# ar2130 due to it gets the box closer to the frame.

 

you can use the same bracket for 525 steering gear. it's just a little bigger and makes steering a lot better. might need a small spacer. dick

 

Agree....C.E., or Pete and Jakes.

4TTRUK

 

Thanx everyone. Going to check out Pete n Jakes and C and E's.

 

The Chassis Engineering one is super solid and gets the box closer to the frame. Also comes with good instructions with real dimensions for the deuce frame.

http://www.chassisengineeringinc.com/page45.html

 

Here's a pic of the chassis eng. vega box mount and their SBC motor mounts in my deuce frame...they nest together really nicely.

 

http://www.welderseries.com
Try Welder Series. They have lots of other bracketry and such too.
Pretty much every Model A and '32 Chassis component you can think of.