Buick 401

I need help i pulled my distributor installed a new ing module now i have no oil pressure checked to see if distrib was fully seated and it is any suggestions

 

Take it to general discussion and you will get more feedback after you do a formal introduction here of yourself.

 

^^x2^^

 

Welcome..

 

pull the dist back out and see if the driveshaft for the oil pump is still in place. Make sure the dist is truly seated. you can get it where it looks like it is down but in fact it needs to go less than 1/4' to seat and will ride on top of the drive shaft.

 

Welcome to the H.A.M.B from Ga

 

First you need help learniong how things work here on the HAMB!

 

Yeah,,Read and see how things work here...not just jumb in where its not proper

 

and note,,AFTER you Introduce yourself..READ the "sticky" at the top of this page..

 

Welcome from So.California

 

intro please