Caddy 3x2 intake manifold?

I picked up and intake this week but I can't find any info on it. It is a Weiand CA3D it looks like its for a 331 365 & 390 cadillac. I tried researching caddy intakes and I can only find offy's edelbrock, edmonds, etc. I am looking for value, rarity, etc.

 

Ive seen a couple of these on the web. Heres a link to one that sold recently, looks a little worse condition than yours.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=190629514027&_trksid=p2992.m753#ht_500wt_949

 

Is it more rare?

 

Totally rare.

 

Great find, yes they are rare.Weiand made really good intakes for Caddys.

 

What is it worth?

 

$5, But I will give you $10 for it right now..lol.. Ebay it.. probably like $500

 

Take a look here for reference purposes.....

http://hotrodcaddy.com/?p=17

 

I'll one up marcus's $10 and give you $20. My gut says the $500 ebay guestimate is probably on the low end. throw a decent set of carbs on it and it would probably go $1200.

 

lol..Thats my old Tech Post..

 

Back in the 90's I could buy these intake for next to nothing..People didnt even know what they were half the time at swap meets.All they knew was it wasnt for a Small block chevy so it was worthless to them..

 

I got this NOS one off Ebay about $250. Manifold only. Re-drilled for Rochester carburetors. Milled carb mounting flanges as close to parallel to crankshaft as I could for a more pleasing look. Regards, Ron

 

Is this an auction cuz I would like to place my bid or hit the buy it now! button if you would be so kind to add one

 

Thanks for all of the info.

 

On the bay now. Starting bid of $499

 

I think that one sold for like $750--I was surprised it went that low.

 

Hey Seabee, I finally found the intake you’ve got on your 390. Something told me to for intakes on eBay and bam, I got me one, I spent over 120 hours of polishing and grinding by hand ,but it was totally worth it . I’ll post more pictures when I get it on the car.I’m still waiting on my carbs from Charlie at vintage speed,I’m excited!!

 

Hey Jeff, good that you found one and in the same place as me. You were a bit luckier than me as mine was set up for stromberg's only and needed modification for to accept the Rochester's. Yeah the polishing was a bitch. Enjoy, Ron

 

Not being a Caddy guy didn't they have a factory tri-power setup ?????

 

Yes.