Register now to get rid of these ads!

Planning an IFS

Discussion in 'The Hokey Ass Message Board' started by richard_b92, Aug 8, 2011.

  1. richard_b92
    Joined: Aug 8, 2011
    Posts: 2

    richard_b92
    Member

    looking for plans to build an IFS for my project I would like to build rather than buy Just need a set of plans in order to get the geometry correct.
     
  2. George/Maine
    Joined: Jan 6, 2011
    Posts: 949

    George/Maine
    Member

    Most after market are like MII because they are at 90 degs easy to find center of axle.I have often wanted to do the same.I guess if you copyed a camaro got the upper and lower a arms maybe race car arms and used camaro spindle and other hardware.
    Copy and get ideas being angled back is lot harder.
     
  3. TomWar
    Joined: Jun 11, 2006
    Posts: 727

    TomWar
    Member

    I built the suspension for my roadster, I attach a couple of pictures, the one thing I feel was important, is having the upper "A" arm angled slightly lower to the rear, to avoid Bump-steer. Mine works and handles great. Good Luck
     

    Attached Files:

  4. dbradley
    Joined: Jan 6, 2007
    Posts: 1,036

    dbradley
    Member


  5. Gator
    Joined: Dec 29, 2005
    Posts: 4,016

    Gator
    Member

    Could you be a little more vague?
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.