Fenton exhaust on 235 question

In the process of installing fentons on the 235, front ones on no problems. The back one however won't clear the stock throttle linkage.(using stock intake for now) I need to either.. A) bend the stock linkage or... B) make a new linkage . I suspect bending the original would be the best bet, but would like some other opinions from those who have done this before .
Thanks Mark

 

Just do a little creative bending. I did and it works very well.

 

Bending it is OK, just make sure it dos'ent get tight and lock up at WOT.

 

bent them in `1963 for the homemade splits, should still work now too!!

 

I took the easy way out on my '56 Chevy and just went with a cable set up.

 

Thanks folks ........as always much appreciated