I had bought this adapter after I got out of the Navy in 1970 and it's been in my stash for all this time. It was for my early Hemi and I think it was for the '68~'69 Wedge 4 speed.I'm not sure! I don't need it but would sure like to know! Do you have any "IDEAS ? Ol Deuce
If you check out this picture I boosted off ebay, the standard mopar A833 has a asymmetric bolt pattern. That plate is the stock hemi trans spacer/starter bracket.
On the starter hump.........NO-** and that all the markings.The bolt spacing is 6"-CtoC and top to bottom is 5 3/4" CtoC. the Face to the trans mount is app. 7". Ol Deuce
DO YOU WANT TO SELL IT. I'M THINKING OF A MANUAL TRANY FOR MY EARLY DODGE 270 PM ME AT [email protected]
DO YOU WANT TO SELL IT. I'M THINKING OF A MANUAL TRANY FOR MY EARLY DODGE 270 PM ME AT [email protected]
Ya ~ I have no need for it but I don't and can't remember what trans it fits..........Send me a PM ....Ol Deuce
Here ya go http://www.jalopyjournal.com/forum/showthread.php?t=312479&highlight=hemi+bellhousing+ford+truck
Little Wing; The adapters are made by the same company but the one in your post was for the '50s ford?? not sure ,top holes are to close ,but getting closer to the mystery Thanks.........Ol Deuce
The A833 is the mopar 4 speed. It originated in 1964 and went through a few different forms into the dark ages (1980s) in trucks and vans. They all pretty much look the same, with a few differences in case material, tail shaft and bearing retainer OD.