Hey guys, I've got an edmunds 2x2 intake for an inline motor. No idea what its for. However I do have the port dimensions if anyone can figure it out. The two outside ports measure 5" center to center. In between those ports is about 9 1/8". Outside port to outside port is 19 1/8". I believe that's the measurements they're a little foggy at the moment. Thanks -J
man ive been looking since you posted.... i went through the internet and old hotrod mags...... i got nothing.... jeez defeated=/ i was thinking either inline 8 or 4 banger. looked at both.
ok well I can tell you what it doesn't fit that we've looked at real quick. Plymouth flathead 6, packard flathead 8, chevy 235 or 216 (obviously), What do you think? Small block chevy? HA HA HA
doesnt look like it fits- hudson 8, buick olds or pontiac 8, packard 8, model A 4 banger, jeep/willys 4 banger, any of the 6's.... im fuckin stumped. also, notice it doesnt have any heat riser.
It not Ford Flat head 6 I just sold a Knudsen and the bore spread doesn't match, not even close. http://www.jalopyjournal.com/forum/showpost.php?p=2673663&postcount=1
im thinking it was literally a one off intake or limited production for a wierd 30s motor. like whippet*spelling* or some off brand.
It is not a Studebaker either. I have the Studebaker Commander 6 one and it's not even close and it's not the Champ 6 one either. And definitely not for a Stude V8.
I don't think that looks right. The ports are to evenly spaced on the intake you're showing. If someone has dimensions that'd be sweet.
hard to tell cuz i couldnt find any out in the open but they looked all pretty evenly spaced. and the holes looked different on the gaskets.
You are correct sir! It fits right up to the pontiac flathead six that just pulled into the shop. Thought I'd let everbody know. -J