Help identifying bed

What year is this bed? The beads in the sides, under where the fenders would be, are different than most model a beds I have seen. It is a Ford, isn't it?

 

Your Kidding Right ??????

How 'bout Since Ya Dont Know What It Is... You Sell It To Me For $50.00 For My Daughters Roadster Pick Up ?? :d

O.k. Fine, Its A '26~'27 Ford "t" Rpu Bed

 

Might be 26 27 T pick up.

 

Its not mine. The guy selling it said it was a model a, that is why I was only looking at those.

 

Its Not An "a" Bed......

See Down Low At The Bottom Of The Bed Where It Would Meet The Frame ? See Its Flat ?

Thats Where It Would Bolt To The Rear Sub Rails On A "t" Rodaster Body.

'26~'27 "t" Bed For Sure..... I Have One On My Daughters '27 Ford Rpu........

 

"T"-Model A front will fit right on. The pushed out sides where the fenders go are different on the T. By using the A fender spacers on the T bed you can gain 3/4" width on each side, just force the running boards and splash shields out a little bit. The spacers will need to be shortened and massaged a bit.