Looking for a good used or new clutch for a 1938 ford not the full size engine Henrys baby ,small engine v8-60 ,clutch is 8.5” x 10 spline , would also be interested in a rebuild kit if available
I got a good used one, had to switch to fine spline for a T5. Lmk and I'll dig it out. Just had a look, 9" disc and PP. Have flywheel too. Was behind a '38 but they're all the same afaik. Lots of meat.
We don’t have any of the 8.5” clutches for the little V8-60. Nobody has produced those for years. You’ll have to find a decent original core and have it rebuilt.
Found the stuff ,PM me for pricing , all parts are nos. The pressure plate has some surface rust , will clean up . Nos throw out bearing ,nos crank bearing . I have a nos ring gear somewhere here too. Didn't look to hard as I figuired you wouldn't be interested in the flywheel . Only used flywheel to show you these are the correct parts Joe
Could it be this one ? https://www.jensales.com/products/h...MI0Ki_8dyC9QIVnP6zCh2EyADgEAQYCCABEgLFNPD_BwE Just wondering, Mike