Technical Have Y'all Seen the New Trick Flow Aluminum Double Hump Heads?

They will have good company with the jacked up pseudo "gassers" and their bolt on spindle mount wheels.

 

If they had done a SERIOUS head that looked like a camel bump, I would be more interested. As it is, those are the sort of numbers I get out of a home ported iron head. I know the vast majority of the HAMB could care less, but for me, that's a swing and a miss. If they had done a 200-210 cc, 300+cfm intake port, they would have more of my interest.

 

Hey George, that gives me an idea.
Maybe I should paint my Rodeck block and Air Flow Research heads Chevy orange.

 

Sold, American!

 

You wouldn't be the first one. Be sure to mix some cast iron filings in the paint so that a magnet will stick them.

 

This set I have flow's North of 325,
Note , water jacket's where off , 1/8 to as much 3/4 inch , head's where cut From 23 deg to 18 deg back in 90's I hand to ball mill channels & drill for water flow , 190 on street .Can not find the pic's

 

Looks like they finally hit the market. This guy got pretty close, post #15.

https://www.corvetteforum.com/forum...beautiful-aluminum-461-double-hump-heads.html

 

These have been out for quite a while, anyone have any 1st hand experience?