Hot Rods Model A quarter/sub frame attachment pics

Anyone have a Model A roadster or coupe build in progress that they can take a few pictures of how they attached the quarter panels to the sub frame. I've looked for videos and posts but nothing shows. Txs

 

I thought I had a few pics of my Brookville body in primer but this was all I could find. If it helps at all?

 

Gordon, Would you have any of the inside That's what I need to see Thank you

 

I'll go back and dig through my pics. The car is pretty much finished or I'd just grab some current ones. Is there a specific area you need to see? Maybe I can grab a shot or two from under it? Inside is going to be tough with carpeting and flooring in there.

 

I'm getting ready to fasten the quarters to the sub frame What ever picture /s you have will help and appreciated Thank you for taking the time

 

perhaps you might check Brookville's web site....!

 

Pretty sure I did I'll look again

 

Here are a couple pics, hard to see but might help. The first shot is from under the car behind the first rivet at the front of the driver side quarter panel and they move back from there, cross member, corner of wheel well and so on... Tough to see but might help.

 

Thank you Yes that helps !!! As in the 1st 2 pics I have those tabs. I thought they were cut out of another piece Thanks again

 

Your welcome.