Register now to get rid of these ads!

Hot Rods 1932 Ford torque tube and drive shaft lengths

Discussion in 'The Hokey Ass Message Board' started by seabeecmc, May 11, 2020.

  1. seabeecmc
    Joined: Jan 28, 2005
    Posts: 1,185

    seabeecmc
    ALLIANCE MEMBER

    What I need are dimensions (length) of a stock '32 FORD model 18 (V8) torque tube and drive shaft. Appreciate the help, Ron
     
  2. Pete Eastwood
    Joined: Jul 27, 2011
    Posts: 1,324

    Pete Eastwood
    Member
    from california

    I'm not sure what your end goal is , but if you are shortening a torque tube on a later rear end , to put it in a 32 , you will need a different dimension .
    The later banjo's are bigger .
    You will need the dimension from the center line of the rear axle to the front of the torque tube.
    The later torque tube will end up being shorter than the 32 torque tube because of the banjo diameter difference.
    Hope this makes sense .
     
  3. seabeecmc
    Joined: Jan 28, 2005
    Posts: 1,185

    seabeecmc
    ALLIANCE MEMBER

    Thanks Pete, my only end goal is to learn the length of the original '32 FORD V8 torque tube and the length of the original V8 drive shaft. Appreciate your input, Ron
     
  4. hightower611
    Joined: Dec 7, 2009
    Posts: 137

    hightower611
    Member


  5. bushwacker 57
    Joined: Oct 3, 2007
    Posts: 630

    bushwacker 57
    Member

    Drive Shaft late 32 51.660 Torque Tube Late 32 53.665 from Ford factory drawings. 2010 Ford Barn.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.