Technical Ford 8" limited slip ID

Can you Identify if this is an open vs limited slip at a glance
Thank You

 

sure, if I were able to glance into the axle holes, and see if the side gears are one piece or two pieces (the second piece is the hub for the clutch)

 

open

 

is that carrier for that housing? the bearing in the second picture does not look pressed on al;l the way

 

I’m with squirrel, can’t tell from those pictures


Sent from my iPhone using H.A.M.B.

 

limited slip or Trac-Lok? take a look at https://www.quickperformance.com/ford-8-inch-trac-lok-posi-unit_p_16014.html & kevinstang.com

 

On a 9" Trac-Lok the ring gear bolts are recessed into the clutch cover. I think the 8" is the same.
Yours looks like an open.

By the way, the Ford 9/8" clutch type limited slips suck because there isn't room for a proper pair of clutch packs. They just get a few disks on one axle shaft that wear rapidly.

 

Not sure if this helps, but this is the Auburn Locker I put in the 8" in my Model A

 

It helps one way...we now know it's not one of those.

 

I think its open.

 

Id like to try an Eaton Tru Trac if I can afford it

 

We know the Trac Lok hat is different, is the other side/half different from an open diff?