I just installed a SBC Offenhauser Dual Quad 360 High Rise intake. It looks like it was designed to only allow a Distributor with out a Vac can on it. So what did y’all use? I have a brand new Delco style Pertronix distributor. Can I remove the vac can on it? I don’t run it hooked up any way. Maybe there’s a lock out bar I can put in it? My other option is to grind away the back of the intake to allow clearance for the vac can. At this point the distributor won’t move advance or retard. This is the Motor spec. 283 30-30 cam Dual Small neck AFB carbs. Deep groove Corvette pulleys Low gears/4 speed/light fly wheel 2300# car *Racer not cruiser Sent from my iPhone using The H.A.M.B. mobile app
I might have to find one of those. Any advice on using what I have now? Sent from my iPhone using The H.A.M.B. mobile app
How about removing the vac can? Any advice or experience with that. I have a stock look Pertronix currently. Sent from my iPhone using The H.A.M.B. mobile app
Here’s the traffic jam I’m working with. I talked to Offenhauser today. Seems like grinding the manifold is what was done to fix this. Sent from my iPhone using The H.A.M.B. mobile app
No way I would grind on that beautiful manifold. Since you’re not using it hooked up, remove the vacuum can, cut off the diaphragm housing and weld the actuating rod solid to the bracket, making your own lock out. Sent from my iPhone using The H.A.M.B. mobile app
Offenhauser told me this intake will be for sale again in the near future. That should bring plenty of views to this post over the years. Sent from my iPhone using The H.A.M.B. mobile app
I sanded an old cap to give me the clearance I needed. The distributor now has some rotation to it. Next I’m going to look at locking out the advance on the distributor. Sent from my iPhone using The H.A.M.B. mobile app
I decided on picking up a used Mallory distributor. The 56 style V8 distributor cap and non vacuum advance is what this intake is designed to use. Sent from my iPhone using The H.A.M.B. mobile app
I got the distributor issue solved with a Mallory Dual point. Thanks for the advice. Sent from my iPhone using The H.A.M.B. mobile app
I just pick up this 36 chevy truck and was trying to get away from points but maybe not. The setup of the engine looks bad ass with the dual carbs.
Tough getting Holleys to fit these intakes, yours is the highrise style, evident by the tall carb pad, then another 2 inches of spacers to get the rear fuel bowl over the top of the distributor. They are great looking intakes.
Hey, I just pick up my ‘36. It’s my Covid 19 stay at home fix everything needs to be gone thru been sitting for 25 years. I just type it up, there it was Mallory unlite electronic distributor PART# 3748201. Say goodbye to two sets of points.