Technical Q. What's the difference between a Quick Change and a 9 inch?

You can use a 9" to get a quickie, but you can't use a quickie to give you 9"!

 

In jest only...

 

Careful or this thread will get 'locked'.

 

me too. Saw title in message board and thought is this one serious ? Turned the page and found out not at all

 

I really appreciate a good laugh after a long hard day.

 

Locked, open, what's the differential?

 

Everyone has a pinion on this.

 

Does this make my rearend look big?

 

YOUR REAR END IS BIG!!!!!

 

Depends on how you like your rear end.

 

I like mine like this.

 

No it's your fat axle that makes it look big

 

All the owners of 9 inchers have lower pinions of those with a QC with higher pinions.
That’s what it seems like anyway.
BTW EX always = Y
Y did you buy that
Y are you going racing
Y do you want another one
Y did you go to the bar
Y do you need new wheels
So X = too many Y’s

 

Congratulations....That was the worst yoke I`ve ever read.

 

Yes,..I know my in-put has no bearing..………...

 

About 300hp.....

 

I see I am out shafted here so I am going to grab my gears and go to another thread and see if I can spin some wheels over there instead.

 

I like both - at the same time.

 

ok-now show us more!!not just a tease...some particulars on that will be followed by EVERYONE!!

 

If you are changing ratios about 40 minutes.

 

Is that for real or for looks ?

 

Only one can be played on a banjo.


Sent from my iPhone using H.A.M.B.

 

Lot of that Dual Stromberg 97 "air" floating around here.