Register now to get rid of these ads!

Technical Installing '39-'48 FORD Brake adjusters

Discussion in 'The Hokey Ass Message Board' started by seabeecmc, Jan 1, 2018.

  1. seabeecmc
    Joined: Jan 28, 2005
    Posts: 1,185

    seabeecmc
    ALLIANCE MEMBER

    Received a PM asking how to install early FORD stainless steel brake adjusters. I figured as long as I was going to respond I might as well post my reply. So here is a pictorial. It does not show the installation of the lower adjusters or wheel cylinder bolts. We do normally drill and tap the fourth wheel cylinder bolt hole just for balance. Regards, Ron 1.JPG 2.JPG 3.JPG 6.JPG 7.JPG 8.JPG 9.JPG 10.JPG 11.JPG 12.JPG adj.JPG
     
    Last edited: Feb 4, 2018
    Hotrodmyk and RICH B like this.
  2. RODIST
    Joined: Dec 29, 2016
    Posts: 154

    RODIST

    Hi, thanks for the post! Happy NEWYEAR !


    Sent from my iPhone using H.A.M.B.
     
  3. butch27
    Joined: Dec 10, 2004
    Posts: 2,847

    butch27
    Member

    Any pics of the lower adjusters ??
     
  4. seabeecmc
    Joined: Jan 28, 2005
    Posts: 1,185

    seabeecmc
    ALLIANCE MEMBER

    The lower adjusters are the stock FORD items with stainless nuts and lock washers as shown in the chrome plated backing plate photo. Ron
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.