Hot Rods Model A Visor advise

I was attempting to attach my 30-31 model A visor today with some new screws on the A-Pillars and the first issue is that them I put the back side on the wood header the holes dont line up on the sides. When I did get the passenger side attached the metal is stretched down on the wood header. This doesnt seem normal to me, especially because nothing lines up.

Second issue is the drivers side screw hole is gone. Its been blown out many many years ago. Im not sure what the remedy is for either but advise/images would help me. Thank you

 

Show us what you got with some pic's first up.
You get better replies if folks can really see what is going on.

 

youre right. Thats where I messed up. I will get images as soon as I can. Thx


Sent from my iPhone using H.A.M.B.

 

I had the same issue. Ended up welding it on. Never looked back.

 

Welded mine on too....then blended it in w little bit of filler

Sent from my SM-G900V using Tapatalk

 

Weld on ain't a bad way to go with a 30 visor.

 

After seeing what Im up against today I may weld it on but Im a long ways away from that point


Sent from my iPhone using H.A.M.B.