Anybody use this for gas in the oil pan, after fix the carb, drain the oil, and new oil and filter. old oil has bad stuff in it filter was plug up was a new motor and now what drop the pan? run it any way? re build? the motor suggesting??? i need help
If you gas fouled your oil and were not running it until it lost oil pressure and toasted the main bearings chances are good that all you need to do it change the oil. if you lost compression then you may need to squirt a little oil down the cylinders to get it running again.
Snake oil, but buy it somebody has a boat payment to make. Metal in the oil? Time to open it up and see how bad it really is. Good luck. -Dave
new motor no miles on it yet just had my shoulder repaired , no wrenching for 3- 6 months i cant open it up
New motor or not metal in the oil sounds like real bad news no matter what the cause. How much gas got in the oil? How long did it run that way? I just drained one that had close to a gallon in it (fuel pump was letting fuel in the crankcase), drained the oil, refilled it. Primed the oil before I fired it, all seems well but I didn't find metal in the drain oil, it had ran maybe 5/10 minutes with gas in it. Good luck.
If you can see metal particles in the oil, large enough to determine the metalurgy, the damage is pretty significant. Unless your viewing these particles under magnification, they are at least 30 - 40 micron in size, which is the limit of human eyesight. For guys like me, it's a lot larger than that, unless I'm wearing glasses anyway. Whatever that snake oil has in it is not going to fill in 40 micron size wear damage.
Old guy told me about engine restore with csl to put in oil was in Msra linechaser last month in The Word by chaplain Connie Warner
I'm done for the year out of work for 3-6 months no money no toys i google engine restorer w/csl but the motor is to bad for that tight motor, piston are pobabbly junk
ok so don't go sit at the pub get into the shed and pull the sump off and show us a main and a big end bearing for a start
new motor as in crate engine? or new motor as in "new to you"? new rebuilt? i seen assembly lube that looked "aluminimy"
is not that easy im 69 years old had a stoke 7 years ago i had to leand to spack i cant read or write very good commuting is hard for me 8 week ago had rotate cup in my shoulder 3-6 mouths healing i had to learn how to fish and hunt doc said no wrenching for 6 months
if i could i would take pan of see how bad bottom piston? motor is tight, ran they to beak the cam woudled tell how long 351w with 302 cam so ran it runing on 4 cyl , yea the do that the cams until the figure out ,long story agine call 763 283 1805 i wold drive it about 10 miles pull fiter and see how bad it is