Register now to get rid of these ads!

Technical Need dimensions for 1922-25 T RPU back panel

Discussion in 'The Hokey Ass Message Board' started by falcongeorge, Mar 13, 2017.

  1. falcongeorge
    Joined: Aug 26, 2010
    Posts: 18,341

    falcongeorge
    Member
    from BC

    Pretty self explanatory I guess, looking for the dimensions of the back panel for a 1922/25 T roadster pick-up body. Particularly the width, and how far down the panel the character line is, also would like to know if its flat, or slightly crowned. Snyders lists one, but it has been listed as "temporarily discontinued" for over a year, doesn't seem that temporary to me, so I am going to make one. Some good clear photos of the panel wouldn't go amiss either, particularly the character line.
    This is the panel that runs between the sides of the bucket at the back.
     
    Last edited: Mar 13, 2017
  2. need louvers ?
    Joined: Nov 20, 2008
    Posts: 12,903

    need louvers ?
    Member

    Hey George,

    I have on loose out back that i can measure for you in the morning. You know me though... If I remember. If you don't hear back from me by noon PM me and i'll get it done for ya.
     
  3. falcongeorge
    Joined: Aug 26, 2010
    Posts: 18,341

    falcongeorge
    Member
    from BC

    Thanks a bunch Chip.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.