Well here it goes..first post on the H.A.M.B. I have been reading it for a while and received a lot of helpful info but i thought i would float this one out there. I recently re-built the carbs on my 28 Roadster pick-up and i am having trouble stopping small leaks on some of the jet plugs in the bottom of the fuel bowl. I purchased all new gaskets from Stromberg 97 ( excellent people to deal with and very helpful too). the seats look good to me and the surfaces were clean, but these little plugs just keep seeping. any suggestions? Is there a different type of gasket i can get?
Uncle Max had (may not anymore) some plugs that had a hex instead of the screwdriver slot. These allow you to get a little more torque on them. He also supplied me with some good gaskets. These cured the problem I had with my 97's. Give Max a call or PM.
Thanks. I e-mailed Max once before for help with jetting....He is a very helpful resource. I'll see about those hex plugs!
I use Permatex Gasket dressing and sealant...(Hylomar) Never hardens and wont allow anything past the threads. Cured my leaking problem 100%
I just fueled mine up and glad to say they do not leak. I did take Clive's advice and I pulled the float bowl screw out ... and used this stuff to seal them up. So far, so good.
Perfect. I was hesitant to put any sealant on those gaskets but that looks like the right stuff. Thanks Sent from my SM-G920W8 using H.A.M.B. mobile app
There are two slightly different gaskets for the jet plugs, paper and "plastic", if it seeps with the paper try the opaque plastic, Max has them, if the plastic leaks send the body to Max and he can reface the seat and they will not leak. He can also reface the power valve seat while he's at it, this will prevent the Power valve gasket from leaking and the inlet valve seat.
Thanks for the advice. I used a little gasket dressing on the jet plugs and it seems like it worked. It's been a couple days with gas sitting in the carbs and one or two of the float screws are seeping now....so one more tear down to address the leaks and all should be good. Although I thought about leaving the original gas stain patina, I prefer to avoid engine fires instead. Sent from my SM-G920W8 using H.A.M.B. mobile app
Hylomar was developed during WWII as a fix for leaking gaskets on the Rolls Royce Merlin engines in the Spitfire fighters used by the RAF. You might say it helped win the war... It'll probably help you win your Stromberg war!
Thanks max. I'm still chasing small leaks on the float bowl/ air horn gaskets too. One day it's good. The next it's seeping. I guess my efforts to true up the gasket surface needs some refining. While we had them apart we used a rubber mallet to flatten the air horns, then lightly sanded on a flat surface. Is it advisable to use any gasket dressing on those gaskets?... Sent from my SM-G920W8 using H.A.M.B. mobile app