Register now to get rid of these ads!
Auctions

1948 Desoto 2dr Sedan

Discussion in 'Cars For Sale' started by thrashingcows, Sep 14, 2015.

  1. City: Abbotsford BC

    State: International (Australia, Canada, etc...)
    Price: 4800 USD
    1948 Desoto 2dr Sedan,

    Very good condition for it's age, original patina paint, Little bit of rust through in trunk spare tire well, and near a couple of the body mounts inside the cabin. Few pin holes in trunk and drivers floor as well. Doors, trunk lip, rockers, fenders are all in great shape!

    Has rebuilt/replacement 25" 218Cu in flat head motor and dry clutch 3spd transmission (No fluid drive)
    New aluminum radiator
    4 x Brand new 15" Coker 3" wide whites, with new inner tubes
    Rims blasted and repainted
    Brake system serviced and rebuilt
    New gas tank and sending unit
    Have all new flat glass for entire car ((clear), and not installed yet))
    Converted to 12V negative ground
    Modern 12V wiring system, all new wires and connections, everything works!
    Installed all New NOS pedals (Gas, brake and clutch)
    1950 Desoto - Door and window cranks

    I have installed a radio delete and clock delete plates, but have the original units to go with car if wanted.

    Also comes with,
    Reprinted Factory Service Manual
    NOS rocker moldings,
    NOS front turn signal chrome bezels ,
    Nice chrome flying woman hood ornament
    Used "Spitfire" Head can go with car if wanted
    Burgandy/red carpet kit
    Nice new chrome bezels for rear tail lights and 3rd brake light
    Nice replacement front bumperettes
    Front Visor, used, no side brackets (not a Fulton)
    Drivers side "Mopar" spot light.
    And Lots of misc parts, new and used, that will go with car if wanted.

    Car is from southern California, and has been registered in BC. Have current registration in hand. Very easy to move this car from Canada to USA....will help buyer if needed.

    Runs good, drives fine around the block. Still needs some work here and there, it's a project so that should be expected. Needs interior upholstery, was very moldy and dry rotted, so most was torn out. Needs new exhaust, I used leftovers from the garage to piece together a basic system.

    Asking $4800 (US funds) or $6000 Cdn OBO.

    You can check out my build thread here.... http://p15-d24.com/t...esoto +fernando

    Willing to work with overseas buyers as well.....Lets work out a deal. ;)

    [​IMG]

    [​IMG]

    [​IMG]
     
    Last edited: Apr 11, 2016
  2. Asking $9000 Cnd OBO.....or open to trades on 600cc snowmobiles. Would like two sleds, pre 2011.

    Lets work out a deal. ;)
     
  3. BTT....

    Asking $8500 Cnd OBO.....or open to trades on 600cc snowmobiles. Would like two sleds, pre 2011.

    Lets work out a deal. ;)
     

  4. BTT....

    Asking $7900 Cnd , or $6350 US , or OBO.....or open to trades on 600cc snowmobiles. Would like two sleds, pre 2011. Or perhaps a nice Dodge Ramcharger?

    Lets work out a deal. ;)
     
  5. BTT....

    Asking $7500 Cnd , or $6000 US , or OBO.....or open to trades on 600cc snowmobiles. Would like two sleds, pre 2011. Or perhaps a nice Dodge Ramcharger?

    Lets work out a deal. ;)
     
  6. Still have this car kicking around. Would like to see it gone.....;)

    Asking $5200 US , or $7000 cnd...OBO! As above open to trades of snowmobile, or quads.
     
  7. Still have this car kicking around. Would like to see it gone.....;)

    Asking $5000 US , or $6800 cnd...OBO! As above open to trades of snowmobile, or quads, or 1980-1993 Dodge Ramcharger 4wd.
     
  8. Spring time...time for a new project.....:)

    Asking $5000 US , or $6500 cnd...OBO! As above open to trades of snowmobile, or quads, or 1980-1993 Dodge Ramcharger 4wd.

    Willing to work with over seas buyers as well.....;)
     
  9. BTT
     
  10. Car has been sold.
     

Share This Page

Register now to get rid of these ads!

Archive

Copyright © 1995-2021 The Jalopy Journal: Steal our stuff, we'll kick your teeth in. Terms of Service. Privacy Policy.

Atomic Industry
Forum software by XenForo™ ©2010-2014 XenForo Ltd.