I have a set of original Cragar direct drilled 4-3/4 bolt pattern I want to use on my car. The front rotors have the 7/16" stud size and that should not be an issue. The rear studs are 1/2" in aftermarket moser axles. When they direct drill the wheels and use the chevy bolt pattern are the wheel holes different sizes for chevy and ford lug nuts and just the thread size different, or will ford shank lug nuts fit these wheels on the rear without doing anything? Thanks
check out this seller 1/2-20 THREAD PITCH -13/16 WRENCH SOCKET -.68"SHANK DIAMETER OR ABOUT 11/16 WIDTH OF THE SHANK -.75"SHANK LENGTH T THE WASHERS ARE CHROME PLATED AND NOT CHEAP BLUE ZINC. THESE WASHER HAVE A .68"INSIDE DIAMETER AND 1.1"OUTSIDE DIAMeter THE THICKNES OF THE WASHER IS .14 http://www.ebay.com/itm/10-OPEN-END...m3aba794086:m:marI6UMcfyvfrJji8cygcuw&vxp=mtr
Most Mag style lug nuts have the same outside diameter on the shanks,,,just thread size is different.