Hello everyone, Just starting a Speedster project. Have a 32 Model B motor. It has the flywheel housing but no bell housing. I have been told the way to mate up a T5 transmission to a Model A is with an AA bell housing. Will the AA bell housing mate to the Model B flywheel housing? Is there a better way to go with a B motor for a modern tranny? Any införmation will be greatly appreciated. Johnny32B
b pan has the lower part of the flywheel housing attached the smaller b upper half of the bell is required too a "AA" bellhousing is 1"shorter to allow for an adapter plate and still have a place for a pedal shaft "AA" bellhousings also have a provision for the wishbone to be mounted where a "BB" does not if your not using stock pedals i would use a reg a bellhousing as they are everywhere and cheaper. make an adaper off of that tk