Hot Rods Brass Injector fitting Man A Fre Manifold

Working on my Man A Fre and have a need for one or two of these injector fittings.
Any one have some lying around?
One side of the elbow is also threaded inside.
Any help woud be appreciated.
Thanks

 

Try Mc master Carr, they should have those.

 

Bump

 

I didn't think Man-A-Fre's used injection parts? More like (4) 2G's or 2GC' carbs?

Where do the parts go on the manifold.

pdq67

 

Below each carb one on each side

 

should be able to take a standard 90 and tap it with a hand tap

 

Yes, most Man-a-Fre setups used Rochester 2GCs, but there were a few equipped with four Scott injectors, if memory serves, but it's been a while. The Scott was "the poor man's injector," using Stromberg 97 bases, throttle bodies, jets and other parts.

jack vines

 

Is this the Man-A-Fre with Scott afterburner system. From what I recall the 'afterburner' system was a constant flow injector system triggered by a solenoid at WOT.

This NOS unit was sold on HAMB in 2014