I have up for sale a solid chopped '53 Ford Vicky. Car was chopped 2 and a half inches in the front and was supposed to be 3 and a half on the back but I never got to finish it. It was squared properly and carefully measured before it was cut and welded back with a 220 volt welder, inner sleeve for strength, and finished off with lead instead of bondo. I welded in frenched mooneyes tail light buckets and also finished them off with lead. there is some left quarter panel damage that any competent bodyman can handle. The car is super solid with no rot except for a small section in front of both rear wheel wells. I also have all the trim, moldings, side glass and interior as well. extras include: all brand new in the box seals and weatherstrips from Dennis Carpenter, brand new wiring harness wired to the dash, 8" diff, plumbed new lines and brakes, set up for a SBC/TH350, brand new never run U.S. Radiator for a SBC, rear roof section/catwalk and top of quarters, NOS Foxcraft skirts from the 50's, etc etc... I have over 7K invested in this project and need the space and $ for my new project. Asking $5,200 obo. I will also consider partial trades with $$$$, let me know what you have. Javier (310)729-9821