Tech Week: How to make 33 Dodge Panels part1

Great thread, thanks for sharing with us.

 

Great work Steve, Keep up the good work mate. Lee

 

you are the man, amazing talent. Thanks for posting

 

wow you make it look easy, i gotta do a bunch of that stuff to my coupe, its always great to see how others attach theses tasks.

 

Thanks Guy's,
I was a Toowoomba swap last month, Australian Street Rodder ran a picture last year I think it was this one , in the swap article.

I have had the same spot on Machinery Hill for a couple of years now.
Cheers Steve.

 

Great tech, thanks. I particularly like the simple piece of shaped tube used to finish the end of a bead.

 

Very impressive!!!

 

is there any chance you could expound on making these quarter tops?
lets say a fella didn't have something to lay a paper template on?
lets say this same fella cant seem to get his power hammer running either?

maybe how this one gets here from a flat sheet.
you mentioned it was cut on a curve with very little shrinking

 

Yes it was cut on a curve to make it like it was pre shrunk.Then the centre of the strip was stretched on a sandbag with a hammer, then rolled out on the wheel.