The Jalopy Journal
Not sure how Forestport could be considered western NY ;)
I have a collection of every issue and can't bring myself to let it lapse
Cut in middle, bore each side for a plug and weld as described above. Still allows for bearing installation/removal.
Shortened the shaft 8" for my '32 PU. The shaft is hollow and just under 1/2" ID. I took the material out of the middle, threaded both ends of...
You'll be in the pits unless for some reason they decide to not honor the pit passes that they sold. Just sayin'
'51ish F100 box in '32 frame. Requires thin spacer under top rear bolt to mount the box perpendicular to the axle[ATTACH] [ATTACH]
Found these 4 large diameter curved glass NOS gauges that I forgot I had while looking for something else a couple weeks ago.
How about shop doors
I plan to use door sweep like the picture on my '32.
at some point you'll have to eat...…………
check out Vinsetta Garage at 27799 Woodward Ave, Berkley, MI 48072
Curt Catallo recreated the well-worn...
I use Delfleet on anything where I want high gloss and awesome wear characteristics.
I think this would depend somewhat on the tire size that you are running. I have 18.5w x 32tall tires on a much heavier car and typically run 10...
you forgot about the two legs
I thought everyone had thousands of magazines from the 40's, 50's and 60's.
Hopefully if you were racing and upside down you are strapped into your seat and "glued" to it.
Separate names with a comma.