The Jalopy Journal
I cut a few pcv valves apart to see the differences inside. All these appear the same on the outside, common GM pcv valves with a plastic elbow......
330' for a street car is better than no track at all, I'd race even 60' if that was all that was available! I hope they make it work. We had a...
I had a .040" 350 that I built with some cheap $89/set H345ACP hyper rebuilder pistons. With pistons down .055"and a .039" head gasket, "quench"...
Looks like he made it... [IMG] Grant
Not sure he will make Friday, told me Saturday... Grant
Talked to Rocky last nite on the phone, the Evil Twin has been repaired and will be at Riverdale in Toutle WA this weekend 8/19/23!!! Grant
My OT street/strip car has a faceplated Toploader that I did myself in 2010 using Liberty parts. Still in the car... Here's a pic of a trial...
Thank you for the feedback! Using your brakes also creates heat and shortens brake life, but as long as you do not overheat them they will last...
For a driver it may not make much difference, but if you have the pickup's original clutch and it will fit the new engine, I would use that. Grant
"Traction control" is a hi-tech way to say power reduction. If they called it what it is, many would look for other solutions. Grant
That was likely me, probably a thread about my original Hillbilly Clutch Slipper that I made 13 years ago from a $15 hardware store hydraulic...
A clutch rating is just a quick/dirty way for the typical aftermarket clutch buying customer to feel assured that the clutch they buy isn't going...
Several scenes with this car in the '58 sci-fi flick "Earth vs. the Spider", saw it on MeTV's Svengoolie show a couple weeks ago... [IMG]
Without any sort of clutch hit controller, the best you can do is a clutch that barely holds after the shift into high gear. You need about 1sec...
Separate names with a comma.