The Jalopy Journal
Great photos and comments. I have the same problem on the upper right corner of trunk gap. I will try the manila and plastic wrap trick to correct...
New question and progress photos. Decided to take a break on body repair and work on chassis. What are the best headers for the 49 with the...
[ATTACH] Thanks for all the help guys.I appreciate all the input. I kept pulling, welding and still could not get the gap I wanted. So I did what...
19fORDY Thanks for the reply and the two videos. I may be heading in the wrong direction. I have not installed the inner metal for the roll pan....
The gap was bad before I removed the floor. I hate to weld in a brace that will always be in the way. I guess I could weld in the roll pan and...
[ATTACH] [ATTACH] [ATTACH]
Need some advice . I'm replacing the trunk floor and the lower roll pan. It was completely rusted out and the previous owner cut a huge hole to...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] The repairs on drivers side went well—- I think I’m getting this shit. Now I have a few questions. Started...
Whoops---newbie here Thanks
Screws, weld a little, remove a screw, weld a little more. I'm sure there is a better way but it worked. LOL
Opinions please. While doing all this sheet metal work, should the gas filler for the 49 stay or go?
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] As promised. Progress has been very slow. Floors were mostly fiberglass repaired. Also learned...
Separate names with a comma.
The Jalopy Journal